Deep throat paper punches

The parts 54 and 52 are of adequate cross section to afford stability to the arm and prevent deection thereof in the use of the holder. A punch and die holder for use in a punch press or the like in which is included a Work-supporting table from which projects a column at a distance rearwardly from the front edge thereof, a guide channel for said holder in said table and having its rear end which is disposed adjacent the front face o1 said column, said holder having a base engageable in said guide channel with its rear end adjacent the front face of said column, the front end of said base being fashioned to support a die, said base having a lateral extension at its rear and at one side, and a shank which is connected to the rear end of said extension and which projects upwardly alongside said column in rear of said base, and an arm projecting forwardly from said shank in spaced-relation to said base to provide therebetween a throat which a workpiece may enter, the front end of said arm overlying the front end of said base and being fashioned to support a punch in axial alignment with said die. A punch and die holder for use in a punch press or the like in which is included a work-supporting table from which projects a column at a distance rearwardly from the front edge thereof, a guide channel for said holder in said table, the rear end of said guide channel terminating adjacent the front face of said column, said holder having a base engageable in said guide channel with its rear end adjacent the front face of said column, the front end of said base being fashioned to support a die, said base having on the top face at its rear end a pad which is continued laterally to one. First Name:. I bought a 3" deep hole punch for showerdrains at Debbie Supply in E. Another object is to provide a novel punch and die holder having a base which is operatively slidable in a channel in the table of the press so that the base of the holder may extend approximately to the column of the press and the shank of the holder may extend past the column to thereby increase the capacity of the holder, with respect to a particular press, over existing holders. From the foregoing description of the construction of the holder H, it will be observed that the punch P and die D are in axial alignment and are disposed in a vertical plane which includes the longitudinal center of the base Sii and press column